Whirlpool WHAB-6015 - Manual (Page 9)

6. Grasp the base of the filter
cartridge with the word “Front”
facing you.
FRONT
FRONT
7. Lay the filter cartridge into the
filterhead valve cradle.
FRON
T
FRONT
9
8. Push filter catridge up into the
filterhead valve until it stops.
The 2 colorstrips should be
aligned (one in the filterhead
valve cradle and one in the
filter cartridge).
FRONT
FRONT
FRONT
FRONT
FRONT
FRONT
IMPORTANT:
Do not install the filter cartridge
as shown below.
11. Take the “B” filterhead valve
and place it at the top right of
the mounting bracket. Pressing
the filterhead valve firmly
against the mounting bracket,
slide the unit downwards
securing both the top and
bottom tabs.
12. Slide the “B” filterhead valve
to the left, making sure the
connector tube goes into the
“B” filterhead valve white collet
“water in”. Slide to the left until
it is centered on the second
mounting bracket. (You should
hear a slight click, when “B”
filterhead valve is secure).
If you do not install the filter C,
put the elbow fitting with the
blue collet into “B” filterhead
valve blue collet “water out”.
13. Repeat step 5 to install filter B.
1
2
10. Place the connector tube into
the blue collet “water out” on
the right side of the first
assembled filterhead valve.
9. Push back on a downward arc
until the filter cartridge stops.
FRONT
FRONT
How to insert tubing
in easy to connect fitting
Collet Body Tube
Figure A Figure B Figure C
Insert the tubing squarely. See figure A.
Make sure to insert tube completely. See figure B.
Push in collet while removing tube. See figure C.