Water supply requirements – Whirlpool WHAB-6015 User Manual
Page 6
6
If local codes permit, connect the UltraEase™ modular filtration
system feed line to the cold water supply line with the ‘’T’’
connector (supplied with UltraEase™ faucets product number
WHAB-6012, WHAB-6013, WHAB-6014, WHAB- 6015 and
DirectHot™ unit WHAF-0115AF).
If you are using the UltraEase™ filtration unit, the Directchill™
unit and/or the DirectHot™* unit should be connected after the
filtration unit.
IMPORTANT: If local codes do not permit the use of the ‘’T’’
connector, special feed valves can be obtained from your local
plumbing supply distributor. Do not connect the filters to the hot
water line. This will ruin the filters. The water pressure to the
DirectChill™ unit or DirectHot™* unit should not drop below
30 psi (min.) nor rise above 100 psi (max.).
Layout 5
If you wish to add the UltraEase™
DirectHot™ unit (WHAF-0115AF)
and the UltraEase™ DirectChill™
unit (WHAF-0115AG), it will
require the UltraEase™ Dual water
filtration Unit A+B (WHAF-0335AB).
IMPORTANT:
A Dual temperature faucet
included with the Direct Hot unit.
It does not require the faucet
model WHAB-6012 or 6013 or
6014 or 6015. UltraEase™
Specialty water Filtration Unit C
(WHAF-0435AC) is optional in
this layout (sold separately).
1. Dual temperature faucet included
with the DirectHot™ unit
2. Cold water supply line
3. White tubing with included
DirectHot™ unit
4. Specialty filtration sold separately
5. Flow monitor included with
DirectHot™ unit
6. “T” water line connector included
with faucet
7. DirectChill™ unit
8. DirectHot™ unit
9. Yellow tubing
10. Red tubing
11. Blue tubing included with chiller
12. Wall mounting clips for tubing
13. White “water in” collet
14. Blue “water out” collet
1
2
3
4
5
6
7
8
11
9
10
12
*Delineated that the DirectHot™ unit is not tested or certified by NSF International.
13
14
Water Supply Requirements