beautypg.com

Flow monitor, Flushing the fitration system faucet features, Faucet care – Whirlpool WHAB-6015 User Manual

Page 12: Before calling for service, Filtration system accessories, Vegetable sprayer, Cleaning

background image

If the faucet does not operate, check these points first:

Has the water supply been turned off?

Check all tubing connections for proper installation.

Make sure filters are intalled properly.

12

12. Open the main water line

valve. Check all connections
for leaks.

IMPORTANT:
Before using the filtration
system, follow the flushing
procedure in the “Flushing
Filtration System” section.

The flow monitor indicates when it’s time to change your
filters. The green light indicates the filtration is good. The
yellow light indicates the filtration is fair. The red light tells
you it is time to change your filter. You will need to replace
the filter(s) cartridge(s) and the two AA batteries in the flow
monitor (included with replacement filter B, WHAB-6010
and replacement filter C, WHAB-6011).

FLOW MONITOR

Before using the filtration system, follow these steps.
1. First make sure the new filters are in place and the water

supply is on.

2. Flush the filters by opening the sink faucet and letting the

water run for approximately 5 minutes. The water will be
dark grey or charcoal colored for a few minutes until the
water is clear.

NOTE: Do not drink water until it runs clear.

FLUSHING

THE FITRATION SYSTEM

FAUCET FEATURES

(WHAB-6014, WHAB-6015 models only)

These two models feature a vegetable sprayer. When needed,
pull down the sprayer to get a mist spray. For a regular flow,
push the sprayer up.

Vegetable sprayer

FAUCET CARE

(WHAB-6014, WHAB-6015 models only)

If you have very hard water, and you notice that the water flow
is reduced, it may be necessary to clean the spout screen.
1. Use a small brush and vinegar to remove hard-water deposit.
2. Turn on/off handle to run water briefly to remove vinegar

and deposits from screen.

Cleaning

BEFORE CALLING

FOR SERVICE...

The filter is expected to last 12 months depending on local water

conditions and the volume of water used. We recommend you

change your filter approximately every 12 months, however, it can

be replaced earlier if there is a drop in water pressure at the faucet.

FILTRATION SYSTEM

ACCESSORIES

WHAB-6009

WHAB-6010

WHAB-6011

Replacement parts

To know your nearest dealer to buy a replacement filter, call
1-866-363-9472 and ask for the part number listed below.
UltraEase™ replacement filter cartridge – Sediment (Unit A):
Part number #WHAB-6009
UltraEase™ replacement filter cartridge – Taste/lead/cyst
(Unit B):
Part number #WHAB-6010
UltraEase™ replacement filter cartridge – Chemicals, VOC’s
(Unit C):
Part number #WHAB-6011

This manual is related to the following products: