Windsor 10080480 - Manual (Page 21)

MAINTENANCE-SERVICE SCHEDULE
86302100 CLIPPER DUO 10/02/07
4-1
SERVICE SCHEDULE
MAINTENANCE DAILY WEEKLY QUARTERLY
Check machine for cord damage *
Check recovery dome and gasket for damage and
cleanliness
*
Check brushes – should be clean with no lint or
strings attached
*
Inspect vac shoe for blockage; remove fibers with
coat hanger, etc.
*
Check hoses for wear, blockages, or damage *
Check handles, switches, and knobs for damage *
Run one gallon of water through solution system *
Clean out recovery tank, clean float screen and
check float valve to make sure it moves freely
*
Clean out solution *
Clean outside of all tanks and check for damage *
Run vac motor for at least one minute to allow motor
to dry
*
Store with dome off tank to allow the tank to dry *
Check all bearings for noise *
Check all gaskets for wear and leakage *
Check pump pressure; observe spray pattern and
check with gauge if necessary
*
Check and clean solution screen *
Check brush for wear; ensure bristles are not
damaged
*
Check condition of vac shoe and frame for damage *
Check overall performance of machine *
Check vac motor carbon brushes *
Check belts for wear and replace as necessary *
Check cables for fraying *