White Outdoor 235 - Manual (Page 10)

10
WARNING: Disconnect the spark plug
wire and ground it against the engine
to prevent unintended starting.
WARNING: NEVER attempt to make
any adjustments while the engine is
running, except where specified in the
operator’s manual.
Lubrication
Lubricate pivot points on the auger control and the
extension spring at the end of the control cable with a
light oil once every season and before storage of the
snow thrower at the end of the season.
Before servicing,
repairing, or inspecting,
disengage the control
bail and stop engine.
Wait until all moving
parts have come
to a complete stop.
Disconnect spark plug
wire and ground it
against the engine to
prevent unintended
starting.
Adjusting Shave Plate
1. To check the adjustment of the shave plate, place the
unit on a level surface. The wheels, shave plate and
augers should all contact level surface. Note that if the
shave plate is adjusted too high, snow may blow under
the housing. If the shave plate wears out excessively,
or the unit does not self-propel, the shave plate may
be too low and needs to be adjusted.
NOTE: On new units or units with a new shave plate
installed, the augers may be slightly off the ground.
2. To adjust, tip the snow thrower back so that it rests on
the handle. Loosen the four lock nuts and bolts which
secure the shave plate to the housing. See Figure 6-1.
Move the shave plate to desired position and retighten
the nuts and bolts securely.
Replacing Shave Plate
The shave plate is attached to the bottom of the auger
housing and is subject to wear. It should be checked
periodically. There are two wearing edges and the shave
plate can be reversed. Refer to Figure 6-1.
1. Remove the four carriage bolts and hex lock nuts
which attach it to the snow thrower housing.
2. Install new shave plate, making sure the heads of the
carriage bolts are on the inside of the housing.
3. Adjust the shave plate according to instructions
above. Tighten the nuts securely before operating the
snow thrower.
Control Cable
As a result of both the control cable and the drive belt
stretching due to wear, periodic adjustments may be
necessary.
If the auger seems to hesitate when rotating while the
engine maintains a constant speed, an adjustment is
necessary. Proceed as follows:
The upper hole in the control handle provides for an
adjustment in cable tension. To adjust, disconnect the
end of control cable from the bottom hole in the control
handle and reinsert it in the upper hole. Insert the cable
from the outside as shown in Figure 6-2. Test the snow
thrower to see if there is a noticeable difference.
Replacing Belt
WARNING: Before servicing, repairing,
or inspecting, disengage the auger
control and stop engine. Wait until all
moving parts have come to a complete
stop. Disconnect spark plug wire and
ground it against the engine to prevent
unintended starting.
6
Adjustments
&
Maintenance
Figure 6-1
Disconnect the
spark plug wire
and ground it against
the engine to prevent
unintended starting.
NEVER attempt to
make any adjustments
while the engine
is running, except
where specified in the
operator’s manual.
WARNING
Figure 6-2
Side View