Wasp Bar Code WWS850 - Manual (Page 3)

1
Update
Restore Default Settings Restore Default Settings Restore Default Settings Restore Default Settings
Exit Setup without Changes Exit Setup without Changes Exit Setup without Changes Exit Setup without Changes
Set Connection Set Connection Set Connection Set Connection
*
Programming Instructions: (1) Read the label. (2) Read the Serial Number barcode
on the bottom of the desired 3666 Base Station within 5 seconds to complete this
setting.
RF Auto Shutdown Duration RF Auto Shutdown Duration RF Auto Shutdown Duration RF Auto Shutdown Duration
*
Programming Instructions: (1) Read the label. (2) Program the desired auto
shutdown duration (in minutes) by reading Decimal Digits on page 53. (3) Read the
“Validate” label (also on page 53) to complete this setting.
Transmit Buffer Setting Transmit Buffer Setting Transmit Buffer Setting Transmit Buffer Setting
Enable
< Disable >
2
Enter Setup
Memory Memory Memory Memory Mo Mo Mo Mode de de de Parameters Parameters Parameters Parameters
• Memory Mode
Enable
< Disable >
• Clear Data
Clear
Confirm
• Send Data
• Memory Data Delay
< 0 >
2 sec
250 ms
3 sec
500 ms
5 sec
1 sec
8 sec