Wasp Bar Code WWS850 - Manual (Page 18)

31
Update
Start / Stop Selection
< abcd / abcd >
abcd / tn*e
ABCD / ABCD
ABCD / TN*E
Plessey Parameters Plessey Parameters Plessey Parameters Plessey Parameters
• Convert to UK Plessey
Enable
< Disable >
• Checksum Transmission
< Enable >
Disable
Telepen Parameters Telepen Parameters Telepen Parameters Telepen Parameters
• Telepen Output
< AIM Telepen >
Original Telepen
32
Enter Setup
MSI Parameters MSI Parameters MSI Parameters MSI Parameters
• Checksum Verification
< Single Modulo 10 >
Double Modulo 10
Modulo 11 & 10
• Checksum Transmission
< Last digit not Transmitted >
Transmitted
Last 2 Digits not Transmitted
• Max / Min Code Length Qualification
Select Max / Min Length Qualification
Max Length *
Min Length *
Programming Instructions: (1) Read the label. (2) Program the desired length by
reading Decimal Digits on page 53. (3) Read the “Validate” label (also on page
53) to complete this setting.