VTech gz5838 - Manual (Page 40)

www.vtechphones.com 40
FCC Part 5
This equipment has been tested and found to comply with the requirements for a Class B digital device under Part 5 of the Federal Communications Commission (FCC)
rules . These requirements are intended to provide reasonable protection against harmful interference in a residential installation . This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications . However,
there is no guarantee that interference will not occur in a particular installation . If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
* Re-orient or relocate the receiving antenna .
* Increase the separation between the equipment and receiver .
* Connect the equipment into an outlet on a circuit different from that to which the receiver is connected .
* Consult the dealer or an experienced radio/TV technician for help .
Changes or modifications to this equipment not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
To ensure safety of users, the FCC has established criteria for the amount of radio frequency energy that can be safely absorbed by a user or bystander according to
the intended usage of the product . This product has been tested and found to comply with the FCC criteria . The handset may be safely held against the ear of the user .
The telephone base shall be installed and used such that parts of the user’s body other than the hands are maintained at a distance of approximately 20 cm (8 inches)
or more . If you choose to use a clipping device, please make sure to only use the supplied VTech belt clip .
FCC Part 68 and ACTA
This equipment complies with Part 68 of the FCC rules and with technical requirements adopted by the Administrative Council for Terminal Attachments (ACTA) . The
label on the back or bottom of this equipment contains, among other things, a product identifier in the format US:AAAEQ##TXXXX. This identifier must be provided to
your local telephone company upon request .
The plug and jack used to connect this equipment to premises wiring and the telephone network must comply with applicable Part 68 rules and technical requirements
adopted by ACTA . A compliant telephone cord and modular plug is provided with this product . It is designed to be connected to a compatible modular jack that is also
compliant . An RJ jack should normally be used for connecting to a single line and an RJ4 jack for two lines . See Installation Instructions in the user’s manual .
FCC, ACTA and IC regulations
This cordless telephone operates within the maximum power allowed by the Federal Communications Commission (FCC) . Even so, this handset and telephone
base can communicate over only a certain distance — which can vary with the locations of the telephone base and the handset, the weather, and the construction
of your home or office.
If the handset receives a call while out of range, the handset might not ring — or if it does ring, the call might not connect well when you press
/FLASH . Move
closer to the telephone base, then press /FLASH to answer the call .
If the handset is moved out of range during a telephone conversation, there might be interference . To improve reception, move closer to the telephone base .
If the handset moves out of range without pressing
OFF, the phone will be left off hook . To hang up properly, walk back within range, periodically pressing OFF .
Operating range