Asus P6-M4A3000E - Manual (Page 54)

4-22 Chapter 4: BIOS setup
Add.On.ROM.Display.Mode.[Force.BIOS]
Sets the display mode for option ROM. Configuration options: [Force BIOS] [Keep
Current]
Bootup Num-Lock [On]
Allows you to select the power-on state for the NumLock.
Configuration options: [Off] [On]
Wait.for.‘F1’.If.Error.[Enabled]
When set to Enabled, the system waits for the F1 key to be pressed when error
occurs. Configuration options: [Disabled] [Enabled]
Hit ‘DEL’ Message Display [Enabled]
When set to Enabled, the system displays the message “Press DEL to run Setup”
during POST. Configuration options: [Disabled] [Enabled]
5.6.3. Security
The Security menu items allow you to change the system security settings. Select
an item then press to display the configuration options.
Security Settings
Supervisor Password : Not Installed
User Password : Not Installed
Change Supervisor Password
Change User Passward
to change
password.
again to
disable password.
BIOS SETUP UTILITY
Boot
Change.Supervisor.Password
Select this item to set or change the supervisor password. The Supervisor.
Password item on top of the screen shows the default Not.Installed. After you set
a password, this item shows Installed.
To set a Supervisor Password:
1. Select the Change.Supervisor.Password item and press .
2. In the password box, key in a password containing up to six letters or
numbers, or both, then press .
3. Confirm the password when prompted.
The message Password.Installed appears after you successfully set your
password.
To change the supervisor password, follow the same steps in setting a supervisor
password.