VTech CS6329-5 - Manual (Page 8)

4
Getting started
Battery charging
Once you have installed the battery, the screen indicates the battery status
(see the table below). If necessary, place the handset in the telephone base
or charger to charge the battery. For best performance, keep the handset in
the telephone base or charger when not in use. The battery is fully charged
after 16 hours of continuous charging. See the table on page 45 for battery
operating times.
If the screen is blank, you need to charge the handset without interruption for
at least 10 minutes to give the handset enough charge to use the telephone
for a short time. When the battery is low, the handset beeps four times every
minute, shows LOW BATTerY and a flashing icon. If you are on a call in
low battery mode, the handset has four short beeps to alert you.
The following table summarizes the battery charge indicators and actions
to take.
Battery indicators Battery status Action
The screen is blank. Battery has no charge
and the handset cannot
be used.
Charge without interruption (at
least 10 minutes).
The screen shows
PLACe IN ChArGer
and flashes.
Battery has very little
charge and the handset
cannot be used.
Charge without interruption (at
least four minutes).
The screen shows
LOW BATTerY and
flashes. The handset
beeps four times every
minute.
Battery has enough
charge to be used for a
short time.
Charge without interruption until
the screen shows hANDSeT X
(about 30 minutes).
The screen shows
hANDSeT X.
Battery is charged. To keep the battery charged,
place it in the telephone base
or charger when not in use.
If you do not plug in the battery into the handset and place it in the telephone base
or charger, the screen displays NO BATTerY.