VTech CS6329-5 - Manual (Page 23)

19
Telephone operation
Mute
The mute function allows you to hear the other party but the
other party cannot hear you.
During a call, press MUTe/
reMOVe
on the handset. The
handset screen shows MUTeD for a few seconds and
MUTE appears until the mute function is turned off.
Press MUTe/
reMOVe
again to resume the conversation.
The handset screen temporarily shows
MICrOPhONe ON.
Temporary ringer silencing
When the telephone is ringing, you can temporarily silence the ringer of the
handset or telephone base without disconnecting the call. The next call rings
normally at the preset volume.
To silence the handset ringer:
Press OFF/
CLeAr
or MUTe/
reMOVe
, rINGer MUTeD
and display.
To silence the telephone base ringer:
Press /VOL- to turn off the base ringer.
Temporary tone dialing
If you have pulse (rotary) service only, you can switch from pulse to tone
dialing temporarily during a call. This is useful if you need to send touch-tone
signals to access your telephone banking or long distance services.
During a call, press
TONe
.
Use the dialing keys to enter the relevant number. The telephone sends
touch-tone signals.
The telephone automatically returns to pulse dialing mode after you end
the call.
Find handset
Use this feature to page all system handsets.
Press /FIND hANDSeT on the telephone base. All idle
handsets ring and the screens show ** PAGING **.
To end paging, press /
FLASh
, , any dialing keys ( 0-9, #,
TONe
) on the handset, or press /FIND hANDSeT on the
telephone base.
1.
2.
•
•
1.
2.
3.
1.
2.
MUtED
3:15
PM MUTE 12/25
RINGER MUtED
Paging rings all the registered handsets even if the ringer
volume is set to off.