Vidikron VP-4200a - Manual (Page 39)

Operation
Vidikron PlasmaView Owner’s Operating Manual 29
PRE
L
IMINAR
Y
5. Click the Advanced button and click the
Monitor tab on the dialog box. Set the
vertical frequency to 60Hz and click OK.
RGB Setup (Input 1 only): After adjusting the computer’s display properties, press the RGB
SETUP button on the remote control to have the PlasmaView automatically adjust the size,
position, and quality of the displayed image.
DVI Setup (Input 2 only): After adjusting the computer’s display properties, configure Input
2 for plug-and-play operation; refer to DVI Setup (Input 2 only) on page 40.
4.6
Changing the Aspect Ratio To change the aspect ratio (size and shape) of the projected image, press the ASPECT RATIO
button repeatedly on the remote control. Select the appropriate aspect ratio for the type of
program material being viewed; refer to Table 4-1.
1. The native resolution of the VP-4200 is 1024 x 768; the native resolution
of the VP-6000 is 1365 x 768. Other horizontal or vertical resolutions
may be scaled upward or downward to fit the display.
2. With most computers, you can get the best picture at 1024 x 768 @
60Hz.
To prevent image retention (burn-in) on your display, ALWAYS use a
screen saver and set it to the shortest possible time.
Note
WARNING
1. Not all aspect ratios are available on some inputs. For example,
Standard 4:3 is not available on Input 5.
2. The aspect ratio selection is saved independently for each input.
Note