Viper 5901 - Manual (Page 17)

14 © 2009 Directed Electronics. All rights reserved.
Basic Commands (Direct Access)
Arm
Press and release
The alarm arms, doors lock (if connected), and the siren
chirps and parking lights flash once. The
ARMED text and beeps play
to confirm and the System Status Icons update. If Valet mode* is On,
the doors lock and the
VALET
text and tone play. Exit Valet mode to
arm the alarm normally.
If a trigger zone fault is detected the siren chirps once again and the
Trigger Zone Fault report** plays.
To Arm and Panic
Press and hold
The alarm Arms (or Locks in Valet) and, after 2 seconds, sounds
the siren and flashes the parking lights. The
PANIC
text and
siren tones play to confirm. Press the or button to stop
the output.
Disarm
Press and release
The alarm disarms, doors unlock (if connected), and the siren chirps
and parking lights flash twice. The
DISARM
text and beeps play to
confirm and the system status icons update. If Valet mode* is On, the
doors unlock and the
VALET
text and tone play.
More than 2 siren chirps and remote beeps indicate a trigger has oc-
curred. The
DISARM
text is replaced by the Alarm report.**
6:30