VTech 20-2481 - Manual (Page 8)

8
Follow the steps below:
1
.
Remove the battery cover by
pressing on the indent and
sliding downward.
2
.
Place the new battery pack in the
handset with the metal contacts
aligned with the charge contacts
in the battery compartment.
3
.
Replace the battery cover by
sliding it upwards.
4
.
If the new battery pack is not
already charged, place the
handset in the base unit, or a
remote charging stand, and allow
it to charge for 12 hours. After
initial charge, a maintenance
charge of 8 hours should be
sufficient.
Installation of Battery Pack in Handset
The original Handset that is shipped with your GIGAPHONE system will be
automatically registered to the Base. This Handset is HANDSET 1.
As you register additional Handsets to the system, they will be assigned
extension numbers in the following order: HANDSET 2, HANDSET 3,
HANDSET 4 , etc.
Whenever a charged Handset battery pack is installed, the Handset will
automatically begin SEARCHING FOR BASE (if previously registered), or
it will prompt you to ENTER BASE ID to register the new Handset. See
Registration and Operation for details.
1
3
2
Getting Started