VTech 20-2481 - Manual (Page 7)

7
Setup
Plug the AC power adapter into an electrical outlet, and the DC connector into
the back of the base unit.
To AC outlet
To telephone
jack
To telephone
socket outlet
AC adapter
8L55
VTECH COMMUNICA
TIONS L
TD .
DC 7V 900mA CLASS 2 PO
WER SOURCE ONL
Y
CORDLESSTELEPHONE
CANAD
A 1 135 102 1814A
REN/IES:
X.X
IC:RSS/CNR
XXX
COMPLIES
WITH 47 CFR P
AR T 68
REGISTRA
TION NO
.: US: EW7 WI00B80-513700
RINGER EQ
UIV ALENCE:
0.0B
USOC J
ACK: RJ11C
, RJ14C
THIS DEVICE COMPLIES
WITH P
AR T 15 OF
THE FCC R
ULES
. OPERA
TION
IS SUBJECT
T O THE FOLLO
WING
TW O CONDITIONS:
1)THIS DEVICE MA
Y
NO T CA USE HARMFUL
INTERFERENCE;
AND 2)
THIS DEVICE MUST
ACCEPT
ANY INTERFERENCE RECEIVED
, INCLUDING INTERFERENCE
THA T MA Y CA USE UNDESIRED OPERA
TION.
PRIV ACY OF COMMUNICA
TIONS MA
Y NO
T BE ENSURED
WHEN USING
THIS PHONE.
FCC ID:
EW780-5001-00
HA C
MODEL :
20-2481
VTECH TELECOMMUNICA
TIONS
LT D.
MANUF
ACTURED IN CHINA
Connecting to the telephone lines
Your 2-Line GIGAPHONE will work fine even if you only have one telephone
line. We recommend connecting the modular telephone cord to the jack labeled
LINE 1 / L1 + L2 , located on the bottom of the Base Unit. Here are steps for
connecting 2 lines:
If you have 2 Lines coming out of a Single Wall Jack:
Connect a 4-wire (RJ-14) modular phone cord between the wall jack and the
phone jack labeled L1 / L1 + L2.
If you have 2 Lines, each coming out of Separate Wall Jacks:
Connect a modular phone cord from the wall jack you want to designate as
your LINE 1, to the LINE 1 / L1 + L2 jack on the bottom of the Base Unit. Next,
connect a phone cord from the remaining wall jack to the LINE 2 jack on the
Base Unit.
Data Port
Your 2-Line GIGAPHONE has a Data Port on the back of the Base Unit. This
port provides an easy way to connect your fax machine, laptop computer,
modem or other telephone device for direct access to LINE 2.
The Data Port only provides access to Line 2, so you must have an active line
connected to the LINE 2 jack on the bottom of the Base Unit. Connect a
modular phone cord from the Data Port (look for the small door marked DATA
on the back of the Base Unit) to your fax, laptop, etc.
NOTE: While the Data Port is in use, accidental use of Line 2 by a parallel
phone, your 20-2431, or a Call Waiting ID alert may interrupt the data transmis-
sion.
Getting Started
RJ-11
One line
cord
RJ-14
2 line
cord
Examples of 1-Line and 2-Line Cords