VTech 20-2481 - Manual (Page 35)

35
Additional Information
Headset Operation
Your GIGAPHONE Handset is equipped with a 2.5mm Headset Jack for use
with an optional accessory Headset for hands-free operation. If you choose to
use the Headset option, you must obtain an optional accessory Headset, which
is compatible with the GIGAPHONE.
To purchase a Headset, call VTECH Customer Service at 1-800-595-9511.
Once you have a compatible 2.5mm Headset, locate the Headset Jack on the
GIGAPHONE Handset. Connect the plug on the Headset cord to the jack on
the cordless Handset. The plug should fit securely. Do not force the connection.
Headset Operation connected to
the Handset
NOTE :
Whenever a compatible Headset is
connected to the cordless Handset, the
microphone on the Handset will be
muted. This is done to limit the effect
of background noise.
Many compatible Headsets have a
reversible, monaural design. You can
wear your Headset on either ear,
leaving one ear free for room
conversation.
FLASH FLASH CLEAR
HANDSFREE VOLUME INTERCOM/
GIGAPHONE 2.4GHz
TRANSFER
L1
1 2 ABC DEF
MNO JKL
TUV
GHI
PQRS
TONE
WXYZ
3
6 5 4
7 8 9
# OPER 0 *
L2 OFF
I
0 # TONE OPER
7 8 9 PQRS TUV WXYZ
4 5 6 GH JKL MNO
1 2 3 ABC DEF
INTERCOM/ TRANSFER
Headset Operation connected to
the Base Unit
The same type of Headset can be
connected to the Base Unit. Facing the
Base, the Headset jack can be found
on the near corner of the right side
panel.When using a Headset attached
to the Base, calls are made and
answered by pressing the HEADSET
key. This key is also used to end your
call. The Base Speakerphone and Base
Headset cannot be used
simultaneously. However, you can
switch between the two modes
without disconnecting your Headset.
Belt Clip
The GIGAPHONE is also equipped
with a detachable belt clip. Align the
pins on the inside edge of the clip with
the notches on the sides of the
GIGAPHONE Handset. The belt clip
should snap securely into place. Do
not force the connection.