Rear panel, Anel, Midi – Vox E 1 User Manual

Page 21: Output

Introduction

Panel Tour

Setup

Program/

Manual

Creating

and Storing

EAR

ANEL

OWER

UPPLY

6.1

~AC9V

Connect the included AC/AC power supply here.

6.2

STANDBY Switch

This switches the unit between operating and standby conditions.

MIDI

7.1

MIDI OUT Jack

This jack transmits MIDI data to control a connected external MIDI device.

7.2

MIDI IN Jack

This jack receives MIDI data to control ToneLab from a connected external
MIDI device.

EDAL

8.1

VOX BUS Jack

For connecting an optional VOX Valvetronix Foot Controller pedal...a must
have item, as you’ll soon discover!

NOTE: Don’t ever connect anything other than a compatable VOX foot controller to
this jack!

OUTPUT

9.1

AMP/LINE Switch

Set this switch for the device that the OUTPUT jack (or S/P DIF OUT jack) is
connected to. You should set this to the “LINE” position if the output jack is con-
nected to a mixer, recording device, if you are using headphones, or if ToneLab
is connected to a power amp. Set this to the “AMP” position if ToneLab is con-
nected to a guitar amp.

9.2

OUTPUT Jacks (L/MONO, R)

These are analogue output jacks (balanced/unbalanced TRS). Connect the L/
MONO jack if you are running in mono.

9.3

LEVEL Knob

This adjusts the level of the OUTPUT jacks and PHONE jack.

9.4

S/P DIF OUT Jack (Digital Output)

This is an optical-type digital output jack in S/P DIF format (IEC60958, EIAJ
CP-1201). It digitally sends the same audio as the OUTPUT jacks at a sam-
pling rate of 44.1 kHz. You can connect it to the input jack of a digital recorder
or other digital audio device.

NOTE: The LEVEL knob does not control the digital output level. Refer to “Adjust-
ing the digital output level,” p.50.