Viking F20465A - Manual (Page 6)

11
S Su urrffa acce e C Co oo okkiin ng g T Tiip pss
•Use low or medium flame heights when cooking in utensils that are
poor conductors of heat, such as glass, ceramic, and cast-iron.
Reduce the flame height until it covers approximately 1/3 of the
utensil diameter. This will ensure more even heating within the utensil
and reduce the likelihood of burning or scorching the food.
•Reduce the flame if it is extending beyond the bottom of the utensil.
A flame that extends along the sides of the utensil is potentially
dangerous, heats the utensil handle and kitchen instead of the food,
and wastes energy.
•Reduce the flame height to the minimum level necessary to perform
the desired cooking process. Remember that food cooks just as
quickly at a gentle boil as it does at a rolling boil. Maintaining a
higher boil than is necessary wastes energy, cooks away moisture, and
causes a loss in food flavor and nutrient level.
10
U Ussiin ng g Y Yo ou urr R Ra an ng ge e
L Liig gh httiin ng g tth he e B Bu urrn ne errss
S Su urrffa acce e B Bu urrn ne errss--A Au utto om ma attiicc R Re eiig gn niittiio on n
To light the surface burners, turn the appropriate control knob
counter clockwise to any position. This control is both a gas valve and
an electric switch. Burners will ignite at any “on” position with the
automatic reignition system. If the flame goes out for any reason, the
burners will automatically reignite if the gas is still flowing. When gas is
permitted to flow to the burners, the electric igniters start sparking.
On all surface igniters you should hear a “clicking” sound. If you do
not, turn off the control and check that the unit is plugged in and that
the fuse or circuit breaker is not blown or
tripped.
Within a few moments, enough
gas will have traveled to the burner to
light. When the burner lights, turn the
burner control to any position to adjust the
flame size. Setting the proper height for
the desired cooking process and selected
utensil will result in superior cooking
performance, while also saving time and
energy.
SS IIMM
MM
EE RR
HH
II
LO
W
T TE EM MP PE ER RA AT TU UR RE E S SE ET TT TIIN NG G G GU UIID DE EL LIIN NE ES S**
HEAT SETTING USE
Simmer Melting small quantities.
Steaming rice.
HI-Simmer Simmering small quantities, sauces.
Low Melting large quantities
Low - Med Low-temperature frying. (eggs, etc.)
Simmering large quantities
Heating milk, cream sauces, gravies, puddings.
Med Sauteing and browning
Braising, pan-frying
Maintaining slow boil on large quantities.
Med-HI High-temperature frying.
Pan broiling
Maintaining fast boil on large quantities
HI Boiling water quickly.
Deep-fat frying in large utensil
*NOTE: The above information is given as a guide only. You may
need to vary the heat settings to suit your personal
requirements.
U Ussiin ng g tth he e T Trriivve ett G Grra atte e
((C Ce en ntte err W Wo okk G Grra atte e))
The trivet grate converts the large
burner grate to a grate suitable
for use with large stock pots. To
use the trivet grate, place the
small grate in the center of the
large grate. Turn the trivet grate
until the feet on the trivet grate
rests inside the notches located
on the center ring of the large
grate.
Trivet grate
feet
Notches
W Wo okk O Op pe erra attiio on n