Viper 5301 - Manual (Page 27)

19 © 2011 Directed Electronics. All rights reserved.
Using your system
➢
Locking the vehicle
To lock the vehicle, press the button on the remote control.
The horn in the vehicle honks one-time, and the parking lights flash one-time. If
the power door locks are connected, the doors lock and the optional Failsafe
Starter Kill activates. The system automatically checks for errors when it locks.
The 2- way remote beeps one-time and then flashes the LED indicator to
confirm locking. If no lock confirmation is received, the remote emits the out-of-
range signal.
If errors are found when locking:
If the door is open when you lock the vehicle, the horn honks once and the
parking lights flash. The horn then honks a second time to indicate that the
door is open and the LED on the Control Center flashes in groups of three. The
2- way remote control sounds a short “error” tone, and the LED indicators next
to the and buttons flash. Note: The optional horn honk and door input
must be installed for this feature to work.
Locking without the honk (Silent Lock)
Press the button on the remote one-time, and then press the button. The
vehicle locks without the confirmation honk. The parking lights flash one-time.
The 2- way remote flashes the LED to confirm locking. If no lock confirma-
tion is received, the 2- way remote emits the out-of-range signal.
Note: When locking in valet mode, the 2- way remote generates a single error
tone, and the and LEDs light up.
➢
Unlocking the vehicle
Press the button one time. The vehicle horn honks two-times and the park-
ing lights flash. The 2- way remote beeps two-times and the LED indica-
tor flashes. If locked the doors unlock and the optional Failsafe Starter Kill
deactivates. If no unlock confirmation is received, the 2- way remote emits the
out-of-range signal.