VIEWSONIC N1750w - Manual (Page 7)

Quick Installation
1 Remove two rear panel covers
2 Connect power cord.
3 Connect video cable
Make sure both the LCD display and
computer are turned OFF
Connect the video cable from the LCD
display to the computer
Macintosh users: Models older than G3
require a Macintosh adapter. Attach the
adapter to the computer and plug the video
cable into the adapter. To order a
ViewSonic® Macintosh adapter, contact
ViewSonic Customer Support.
4 Turn ON LCD display and computer
Turn ON the LCD display, then turn ON the
computer.
NOTE: Windows users may receive a
message asking them to install the INF file.
Note: go to www.ViewSonic.com
5 Audio Installation (optional)
Speakers Connect the audio cable (line
color) to the AUDIO OUT port of your
computer’s sound card, then to the LCD
display’s AUDIO IN (line color) port (see
illustration below).
6 Windows users: Set the timing mode
(resolution and refresh rate)
Example: 1280 x 768 @ 60 Hz.
For instructions on changing the resolution
and refresh rate, see the graphic card’s user
guide.
7.Installation is complete. Enjoy your
new ViewSonic, LCD display.
You can register your product online at the
website for your region. See the Customer
Support table in this guide. (page 32)
5