Vizio XMF1000 - Manual (Page 7)

4
3. Remove 1 lag bolt and 1 washer from the pouch labeled
LAG.
Place
part A against the wall as shown, and use a wrench to
insert the lag bolt and washer into the hole you just drilled.
4. Push the bar through the opening in the bracket ( part A) as
shown.
Push the other bracket ( part A) onto the bar and hold it flat
against the wall. Ensure it is over the stud.
Snap on the leveler ( part E) and level the bar.
Mark the location of the hole in the bracket as shown.
5
3
Use Bottom Hole
Push Bar Through
Level Bar Make Mark