Manual configuration – Vantec UGT-ST310R User Manual
Page 7
UGT-ST310R Page
7
3. Select
RAID0, then press Enter.
4.
Select the number of drives then press Enter.
5. Select
Auto configuration, then press Enter.
6.
Input the RAID size, press Enter.
7. When
asked
Are You Sure (Y/N)?, press Y to accept.
8. Press
Ctrl+E to exit the BIOS.
9. When
asked
Are you sure to exit (Y/N)?, press Y to exit
and reboot.
10. Continue with FDISK and FORMAT steps as if you were
installing a conventional hard drive.
Manual configuration
1. As the BIOS boots press Ctrl+S or F4 when prompted to
enter the RAID BIOS.
2. At the next screen select Create RAID Set, then press
Enter.
3. Select
RAID0, then press Enter.
4.
Select the number of drives then press Enter.
5. Select
Manual configuration then press Enter
6. Select chunk size from 8k, 16k, 32k, 64k or 128k, then
press Enter.
7. Select
the
first drive, press Enter.
8. Select
the
second drive, press Enter.
9. If applicable select the 3rd
and 4th drives pressing enter
after each selection.
10. Input the RAID size, press Enter.
11. When
asked Are You Sure(Y/N)?, press Y to accept.
12. Press
Ctrl+E to exit the BIOS.
13. When asked Are you sure to exit(Y/N)?, press Y to exit
and reboot.
14. Continue with FDISK and FORMAT steps as if you were
installing a conventional hard drive.