Vantec UGT-ST310R - Manual (Page 13)

UGT-ST310R Page 13
and reboot.
15. Continue with FDISK and FORMAT steps as if you were
installing a conventional hard drive.
CONCATENATION (JBOD)
This RAID array allows you to use one, two, three or four hard
drives to a array. It does not provide any data protection or
performance improvement but can be useful for utilizing leftover
space on disks.
1. As the BIOS boots press Ctrl+F4 or F4 when prompted to
enter the RAID BIOS.
2. At the next screen select Create RAID Set, then press
Enter.
3. Select CONCATENATION, then press Enter.
4. Select the number of drives then press Enter.
5. Select
the first drive, press Enter.
6. If applicable select the 2nd, 3rd, 4th drive pressing enter
after each selection.
7. When asked Are You Sure(Y/N)?, press Y to accept.
8. Press Ctrl+E to exit the BIOS.
9. When asked Are you sure to exit(Y/N)?, press Y to exit
and reboot.
10. Continue with FDISK and FORMAT steps as if you were
installing a conventional hard drive.
Deleting RAID Arrays
1. As the BIOS boots press Ctrl+S or F4 when prompted to
enter the RAID BIOS.