Vantec UGT-ST310R - Manual (Page 10)

UGT-ST310R Page 10
use existing hard drive(s) with data. To create a RAID 0+1 set
four hard drives are required.
Auto configuration (recommended)
The default chunk size is 64k when selecting Auto
configuration.
1. As the BIOS boots press Ctrl+S or F4 when prompted to
enter the RAID BIOS.
2. At the next screen select Create RAID Set, then press
Enter.
3. Select RAID10, then press Enter.
4. Select Auto configuration, then press Enter.
5. Input the RAID size, press Enter.
6. When
asked Are You Sure(Y/N)?, press Y to accept.
7. Press Ctrl+E to exit the BIOS.
8. When asked Are you sure to exit(Y/N)?, press Y to exit
and reboot.
9. Continue with FDISK and FORMAT steps as if you were
installing a conventional hard drive.
Manual configuration
1. As the BIOS boots press Ctrl+S or F4 when prompted to
enter the RAID BIOS.
2. At the next screen select Create RAID Set, then press
Enter.
3. Select RAID10, then press Enter.
4. Select the number of drives then press Enter.
5. Select
Manual configuration then press Enter.