VIEWSONIC VS12280-1A - Manual (Page 14)

Getting Started
Contact ViewSonic service team at: http://www.viewsonic.com.au/ or call our service team: Australia 1800 880 818
ViewSonic 9 N3290w/N4290p/ N4790p
Mounting ViewSonic LCD TV to the wall
The LCD TV can be used in a free standing position or wall-mounted. Before installing
the product to the wall, please consider the following guidelines:
z Read the Important Safety Instructions, at the start of this manual.
z Do not install in a moist or wet environment. This equipment is intended for
indoor use.
z Do not install near heat source, or strong magnetic fields
z Use only ViewSonic approved wall-mounting brackets to support the LCD TV
weight
z Before attaching the wall mount plate to the back cover, ensure the product is
working
z If your LCD TV is already set up for free-standing operation, you need to first
remove the stand before mounting the device to the wall.
To attach the wall-mount bracket to LCD TV safely, please use the following guidelines:
z Disconnect the power and any other cables that might hinder moving the LCD TV.
z Set the LCD TV on a table or work surface, placing the screen face down on a
towel or woolen blanket to protect the screen surface from damage while
installing plate.
z Through the matching screw holes in the bracket, there are 4 or 6 screws
mounted on the backside of the LCD TV. Loosen all screws, and keep for future
use.
z Install the wall mount plate to the LCD TV using screws NO LONGER than 10mm,
as longer screws found in universal (non-ViewSonic) wall mount kits may
damage the power supply causing the unit to fail. N3290w, N4290p and N4790p
wall-mount screw type is M6 x L10.
z Mount the wall mount bracket to the wall ensuring use of proper screws to
support the installation. Ensure there is at least 6cm of space surrounding any
air-vents of your LCD TV to allow adequate cooling during operation.
z Hang the LCD TV wall mount plate to the wall mount bracket, completing
installation. Enjoy your ViewSonic LCD TV