Viking Combination Beverage Center User Manual
Page 15

15
TROUBLESHOOTING CHART
P
Prro
ob
blle
em
m
P
Po
ossssiib
blle
e C
Caau
usse
e
S
So
ollu
uttiio
on
n
Odor in cabinet
Interior needs cleaning.
Clean the interior using a solution of baking
soda and war water or water and mild soap
Unit operates but does not
The unit has just been started and it
Typical ice production is 2 lbs per day. Allow
produce any ice
has been less than 24 hours.
for the freezer section to reach temperature
and the ice maker to cycle and accumulate
ice.
Water supply is not turned on.
Turn on water supply to the unit.
Inadequate water pressure to unit.
Water pressure must be at a minimum 20 psi.
The ice maker bale arm is in the
When the ice maker arm is in the uppermost
uppermost position
position, the ice maker is off. Flip the bale
arm down to turn on the ice maker.
Freezer section has not reached
Allow the freezer section to reach
temperature.
temperature.
Thermostat control knob is too warm.
Turn the temperature control knob to a
higher number to allow the unit to run
colder. Allow 24 hours before readjusting
the temperature control.
Blower inlet and/or outlet is restricted. Keep blower area clear from commodities for
proper operation.
Condenser fan air flow is restricted.
Make certain the grille in front of the unit is
free and open for proper air circulation.
Check and clean the condenser coil by
removing the grille in the front of the unit.
Clean the condenser with a vacuum and
brush attachment.
Room and/or water temperature is too Move the unit to an area where ambient
warm.
temperature is below 90
o
F. The unit should
not be placed next to a heat source such as
an oven. Check for cold water connection.
Small ice cubes
Water input may require adjustment
Due to differing water pressures, the ice
maker water input may require adjusting.
Noisy operation
Cabinet not level;
Adjust the leveling legs on the unit.
weak floor structure.
The unit must be locate on a sound and
sturdy floor for proper operation.
Water line tubing vibration
Adjust the tubing as necessary to prevent
unwanted vibrations.
Ice cubes sticking together.
Ice consumption is low.
Use the ice in the bin frequently. Ice will
stick together if left in insulated bin over
long periods of time.
Room temperature is too warm.
Move the unit to an area where temperature
is below 90
o
F.