Viking F20528 - Manual (Page 5)

9
Ceramic Glass Cooktop
All products are wiped clean with solvents at the factory to remove
any visible signs of dirt, oil, and grease which may have remained from
the manufacturing process. Clean your glass top before the first
time you use it. A thorough cleaning with a glass top cleaner is
recommended.
Induction Cookware
Induction cooking utilizes magnetic power which reacts with iron in the
base of cookware, instantly transforming the pot or pan into the heat
source. The heat stops when the cookware is removed. Your cookware
MUST have a magnetic layer of steel for your induction cooktop to
operate properly. The cookware should have a flat, heavy magnetic
bottom and straight sides with a diameter of 5” (13 cm) to 12” (31 cm)
to accommodate the various sized elements. The induction cookware
should be in good condition and free from excessive dents on the
bottom to provide maximum performance and convenience.
All Viking cookware is induction friendly, as are
most other high-end brands of stainless
steel and enamel cookware. Most
induction cookware will be suitable for
your induction cooktop if a magnet
adheres to the bottom surface.
• Cookware that is NOT suitable for your
induction cooktop includes pottery, glass,
aluminum, copper, bronze, and any type of cookware with
a footed base.
Before Using Cooktop
G
e
tt
in
g
S
ta
rt
e
d
8
G
e
tt
in
g
S
ta
rt
e
d IMPORTANT–
Please Read and Follow
12”
(30.5
cm
) m
ax.
5”
(12.7
cm
) m
in.
Radio Interference
This unit generates, uses, and can radiate radio frequency energy and,
if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If
this unit does cause harmful interference to radio or television
reception, which can be determined by turning the unit off and on, the
user is encouraged to try to correct the interference by one or more of
the following measures:
• Reorient or relocate the receiving antenna
• Increase the distance between the unit and receiver
• Connect the unit into an outlet on a circuit different from that to
which the receiver is connected.
KEEP THESE INSTRUCTIONS FOR FUTURE REFERENCE.
WARNING
BURN OR ELECTRICAL SHOCK
HAZARD
To avoid risk of injury or death, make sure all
controls are OFF and surface is COOL before
cleaning. Failure to do so can result in burns or electrical shock.
CAUTION
BURN HAZARD
To avoid risk of injury, DO NOT touch the glass. The cooktop
will get hot during usage.