Vanguard Managed Solutions 650 - Manual (Page 28)

1-14 Getting Started
Software
Software
Introduction This section briefly describes the operating software for Vanguard 650 Series
devices.
Operating Software The operating software comes in three formats: Base, Boot, and Option. There are a
variety of operating software images available for the Vanguard 650 Series. See the
Software Release Notice accompanying your product for feature information on
available operating software. See the “Installing Software” section in Chapter 3 for
information on installing the operating software.
Optional Feature
Software Some options purchased for the Vanguard 650 Series require a Software Access Key
(SAK). The SAK enables software options and, if you have purchased an option
requiring it, the SAK will be identified on a SAK Acknowledgment Sheet, see
Figure 2-1.
If you are required to enter a SAK refer to the following sections.
Enabling a SAK When you purchase a software option, you receive a 20-character Software
Authorization Key (SAK) to enable the option. The SAK corresponds to the serial
number of your Vanguard 650 Series, so it cannot be used on any other node. To
enter the SAK key:
Step Action
1 Select Configure ->Software Key Table from the CTP Main menu.
2 At the Entry prompt, select a new entry. Make sure you do not overwrite
existing SAK entries.
3 At the Key Value prompt, type in the 20-character code followed by a
semicolon (;) to save the SAK.
4 Boot the node.