VTech i 5803 - Manual (Page 9)

9
Getting S
tarted
Connecting to Phone Line
Plug one end of the telephone line cord into the jack on the
bottom of the Base Unit. Plug the other end of this cord into
the wall jack.
Checking for Dial Tone
After the battery cells are charged press
ON
on the Hand-
set. The Phone icon will appear on the Handset dis-
play, and you will hear dial tone. If not, see
In Case of
Difficulty.
Tone/Pulse Selection
Your
i 5857
is preset for tone dialing. See
Settings/Base Settings
for details.
CAUTION
: Use only the VTech power supply provided with your telephone.
IMPORTANT:
1. Do not dispose of battery cells in a fire, the cell may explode.
2. Do not open or mutilate the battery cells. Toxic substances may be released,
causing harm to eyes or skin.
3. Exercise care in handling battery cells in order to prevent an accidental
short of the charge contacts, potentially causing the battery pack to overheat.
4. Do not dispose of battery cells into household garbage. They should be properly recycled.
IMPORTANT:
FOR MAXIMUM PERFORMANCE OF YOUR
CORDLESS TELEPHONE SYSTEM:
1. Choose a central location for your Base Unit.
2. Install your Base Unit and Extension Handsets
away from electronic equipment, such as personal
computers, television sets and microwave
ovens.
3. In locations where there are multiple cordless
telephones, separate base units as much as
possible.
4. Install your telephone equipment away from heat
sources and sunlight.
5. Avoid excessive moisture, dust or extreme cold.
Setup