Viper Model 3002 - Manual (Page 30)

31 © 2 0 0 6 d i r e c t e d e l e c t r o n i c s
2. Decrease Sensitivity—Press and release the button to
decrease shock sensor sensitivity by one step. The siren will
chirp 1-time for each step decreased in adjustment. When the
shock sensor adjustment reaches minimum sensitivity (sensor
is Off ) the siren will emit 1 short and then 1 long chirp.
3. Testing Sensor—Use the heel of the palm of your hand to
strike the door pillar of the car after an adjustment. The siren
will chirp once if the impact was great enough to generate a
full trigger. Pre-warn level is set automatically. When desired
setting is reached, sensor adjustment mode can be exited.
exit shock sensor adjustment mode
The adjustment mode will be exited if:
➤ No input from transmitter for 15-seconds.
➤ No input from sensitivity testing for 15-seconds.
➤ The ignition is turned On.
➤ The Valet button is pressed.
The siren will emit 1 long chirp and the LED will extinguish
which shock adjustment mode is exited.
reset shock sensor to default setting
The shock sensor can be restored to a default setting of 10 to
facilitate re-adjustment at any time while in adjustment mode.
1. Simultaneously press the and buttons.
➜
➜