Viper Model 3002 User Manual

Page 21

After each press of the

to reach the next level of security, the

remote will emit normal arm notification (1 beep and 3 flashes

of the Orange LED). For easiest operation in reaching each level

of security, press

immediately aafftteerr each notification.

disarming

To disarm the system, press

. You will hear two chirps, and

the parking lights will flash twice. If the power locks are

connected to the system, the doors will unlock. If the siren chirps

either four or five times when disarming, refer to the Diagnostics

section of this guide. This is called Tamper Alert.

The remote will indicate disarm notification with 2 beeps and 3

flashes of the Orange LED. If disarming after the system has

been triggered, the remote control will send a diagnostic notifi-

cation as a reminder. These diagnostic notifications are:

1. If a sensor triggered the system, the remote will beep 4-times

and the Orange and Red LEDs flash 3 times.

2. If a switch (Zone 1, 3, 5, or 6) triggered the system, the

remote will beep 4-times, the Orange LED will flash 6-times

and Red LED will illuminate for 3 seconds.

3. If the system was triggered so many times that NPC is active

the remote will emit the above notifications with 5 beeps

instead of 4.

➜

note: Multi-Level Security Arming only applies to a sin-
gle arming cycle. Once the system is disarmed and then
re-armed, all the zones will be active again.