Vertex Standard PS1000 - Manual (Page 27)

Page 27 Phantom PS1000
10.12 SCANNING
Allows the user to select the scan type from Memory scan or Priority scan.
“Memory scan” scans the channels that were programmed into memory. “Pri-
ority scan” scans the channels programmed in memory with the priority chan-
nel.
10.12.1 Selecting the Scan Type
Operator can select which is the scanning feature start the “Memory Scan (M-
SCAN)” or “Priority Scan (P-SCAN)” when pressing the [SCAN] key.
1. Press and hold down the [CALL(SET)MENU] key
until “ RADIO SETUP ” menu appears.
2. Press the [CALL(SET)MENU] key, then press the
[ ] key to select “ SCAN TYPE ” menu.
3. Press the [CALL(SET)MENU] key.
4. Press the [
] or [ ] key to select “ PRIORITY ” or
“ MEMORY .”
5. Press the [CALL(SET)MENU] key to store the se-
lected setting.
6. To exit this menu and return to radio operation mode press
the [16/9] key.
You may start the non-selected scanning feature which is determined above
procedure by press and holding the [SCAN] key while activating the Scanner.
10.12.2 Memory Scanning (M-SCAN)
1. Set the squelch level to the “squelch threshold” (the background noise is
muted).
2. Select a desired channel to be scanned using the [ ] or [ ]
key, then press and hold the [SCAN] key. “MEM” will appear
on the LCD which indicates the channel has been pro-
grammed into the transceivers memory.
3. Repeat step 2 for all the desired channels to be scanned.
4. To DELETE a channel from the transceiver’s memory, select the channel
then press and hold the [SCAN] key, “MEM” will disappear in the LCD.
5. To start scanning, press the [SCAN] key momentarily.
“ M-SCAN ” appears on the LCD. Scanning will proceed from
the lowest to the highest programmed channel number and
will stop on a channel when a transmission is received.
6. The channel number will blink during reception.
7. To stop scanning, press the [SCAN], [CALL(SET)MENU], [WX], [16/9], [DIS-
TRESS], or PTT key.