Vertex Standard PS1000 - Manual (Page 19)

Page 19 Phantom PS1000
PWR key
NOTE
The Phantom PS1000 is designed to be flush mounted or bracket
mounted in a dry cool area when there is limited mounting areas. When
it is bracket mounted the power switch on the Phantom PS1000 is not
used instead use the PWR key located on the top of the RAM+ mic(s).
Turns the transceiver on and off. To turn the transceiver on, press and hold
this key until this switch illuminates orange. To turn it off, press and hold this
key until the illumination turns off. When the power is turned on, the trans-
ceiver is set to the last selected channel.
This switch is connected in parallel with the switch with the same name on
the front panel of the CMP25 RAM+ Microphone.
RAM+ MIC CONNECTOR
Connects the Phantom PS1000 to the CMP25 RAM+ Microphone.
ACCESSORY CONNECTION CABLE
Connects the Phantom PS1000 to a GPS. See section “3. OPTION” for a list
of speakers STANDARD HORIZON offers.
DC INPUT CABLE
Connects the radio to a DC power supply capable of delivering 12V DC.
ANTENNA JACK
Connects an antenna to the transceiver. Use a marine VHF antenna with
an impedance of 50 ohms.