Viking F20537B EN - Manual (Page 10)

19
Surface Operation Surface Operation
O
p
e
ra
tio
n
Heat Setting Use
Simmer Melting small quantities
Steaming rice
Simmering sauces
Low Melting large quantities
Med Low Low-temperature frying (eggs, etc.)
Simmering large quantities
Heating milk, cream sauces, gravies,
and puddings
Med Sautéing and browning, braising, and
pan-frying
Maintaining slow boil on large quantities
Med High High-temperature frying
Pan broiling
Maintaining fast boil on large quantities
High Boiling water quickly
Deep-fat frying in large cookware
18
O
p
e
ra
ti
o
n
Rear and Front Elements
Push in and turn the control knob
counterclockwise to the desired setting. The
element will adjust the power output to maintain
the desired heat setting. The left front burner has
a “Boost” feature. A boost of power is provided
for 10 minutes and is used for quickly boiling
water when the element is turned to HI. When
finished boiling, turn the control knob to Med HI to maintain the boil or
to a lower setting for steaming, warming, and simmering sauces.
Note: Viking induction cooking uses high powered induction elements
for faster cooking performance. Some noise may be noticed by the
high powered induction elements. This is normal.
Surface Indicator Lights
The surface indicator lights are located at the front
of the glass cooktop. The
indicator lights are used to
indicate activation, hot surface,
and warnings.
Note: If the indicator lights have a 2 to 3 second pause in between
flashes, refer to the “Troubleshooting” section.
Indicator Light Reason
Solid The element is ON and sensing the proper
cookware.
Slow continuous flash
without a pause 1. Element is OFF - hot surface.
2. Element is ON - cookware is not present or
cookware is not induction cookware. (See
recommended cookware in “Before Using
Cooktop” section.)
Fast continuous flash
without a pause The element is ON - surface temperature is very
hot. The power level is regulated to a lower
temperature setting as the internal temperature
inside the cooktop has increased due to
extended use.
WARNING
DANGER
CAUTION
FOR YOUR SAFETY
Do not heat empty cookware or let cookware boil dry. The cookware
can absorb an excessive amount of heat very quickly, resulting in
possible damage to the cookware and ceramic glass.
Note: The above information is given as a guide only. You may need
to vary the heat settings to suit your personal requirements.
Surface Heat Settings
HOT
REAR
FRONT FRONT
REAR HOT
Surface Cooking Tips
• The minimum pot or pan diameter recommended is 5” (13 cm).
Use of pots or pans as small as 4” (10 cm) is possible but not
recommended.
• Remember to use the proper size cookware for the size element
chosen. Smaller cookware should be used for smaller elements and
larger cookware should be used for larger elements.
Note: If ALL elements are turned to HI for a long period of time, the
internal temperature inside the cooktop may rise, causing the cooktop
to turn off.
Remember that induction cooking is instantaneous and boiling time is
decreased when using the proper induction cookware.