Uniden DG72 - Manual (Page 12)

8
Installing the Battery Pack
The rechargeable battery pack must be fully charged before using your phone for
the first time. Before plugging the phone line into your new phone, you must
charge the battery for approximately 15-20 hours without interruption.
1. Remove the Handset
battery cover.
2. Plug the battery’s cable into the
handset press the plug in firmly
until it clicks into place. Place
the battery pack inside the battery
compartment.
3. Replace the battery cover.
Charging the Battery Pack
▼ Initial battery charging
Before connecting your the phone line for the first time, fully
charge the rechargeable battery pack for 15-20 hours
without interruption.
1. Place the handset on the base
(facing up or down).
2. Make sure that charge LED lights.
If the LED doesn’t light, be sure the AC
adaptor is plugged in and the handset
makes good contact with the base
charging contacts.
▼ Low battery indicator
The low battery indicator shows when the
battery pack is very low and needs to be charged.
If the phone is not in use, the
batt low LED
flashes every four seconds. If the phone is in use,
the
batt low LED flashes every four seconds
and the handset beeps. Complete your
conversation as quickly as possible and return
the handset to the base for charging.
charge
INSTALLING & CHARGING THE BATTERY PACK
!
The battery connector
will fit together only
one way. Make sure the
connector is properly
aligned. Use only the
Uniden battery pack
(model BT-434)
!
It is recommended to
place the handset on
the base after use if
convenient. However
recharging the battery
is only necessary when
the low battery
indicator is lit.