Programming systems menu, Using the menu – Uniden BCD396T User Manual
Page 51
51
Using the Menu
Programming Systems Menu
This table shows the scanner’s systems menu
structure. This menu lets you program new systems or
change existing systems. To find information about a
particular menu setting in this manual, go to the page
number shown under or next to the setting.
To use the systems menu, press
then briefly
press the scroll control. To back up a level, press
. To exit the menu mode, press
again.
Note: Not all of the options shown in this table may
appear at the same time. To view all available options
on any screen, rotate the scroll control
Menu/
Submenu
Option Menu
Menu
Menu
Menu
Select Sys Type
Srch/CloCall Op
MOT
EDCS
LT
Conventional
System 1 C
Srch/CloCall Opt
Edit Sys Option
Edit Group
Delete System
Copy System
Edit Name
Select Sys Type
Srch/CloCall Op
EDCS
LT
Conventional
MOT
System 1
Srch/CloCall Op
800MHz Splinter
900MHz band
VHF Band
800MHz Standard
P25
UHF Band
System 1 M
Srch/CloCall Opt
Edit Sys Option
Set Frequencies
Set Modulation
Set Attenuator
Edit Name
Edit Group
Delete System
Copy System
Select Sys Type
LT
Conventional
MOT
EDCS
EDCS
Srch/CloCall Opt
SCAT
NARROW
WIDE
System 1 E
Srch/CloCall Opt
Edit Sys Option
Set Frequencies
Set Attenuator
Edit Name
Edit Group
Delete System
Copy System
“Programming Conventional
Systems” on Page 61
“Programming EDACS Systems”
on Page 67