Using multiple bases – Uniden DECT 6015 User Manual
Page 22
21
Using Multiple Bases
DECT 6005 handsets and the handsets supplied with your phone can be registered to a total of four different
DECT6015 or DECT6035 bases. Once your handset is registered to more than one base, you can set the handset to
search automatically the available base, or you can select manually which base the handset should connect to (for
example, if you have one base with an answering machine, you can tell the handset to connect that base to check
messages).
Registering the Handset to Another Base
To register a handset to another base:
Make sure the handset battery is fully charged.
1)
On the base, disconnect the base AC adapter. Then press and hold
2)
[fi nd hs] while you reconnect the adapter.
Keep pressing [fi nd hs] until the charge LED starts to blink.
On the handset, Press
3)
[Menu/Select]. Select the REGISTER BASE menu. HANDSET REGISTERING will
appear in the display.
Wait approximately thirty seconds. “REGISTRATION COMPLETE” will be displayed to indicate the handset has
4)
been registered to the base and a handset ID will be automatically assigned.
If REGISTRATION FAILED appears in the LCD, please try these steps again.
Selecting the Base
When your handset is registered to another base, it will automatically connect to the base. A base ID (that is for the
handset only) will be assigned in the order of registration. You can either select a base you want to use manually, or
set to AUTO. If you set to AUTO, when the handset comes out of range, it searches automatically the available base
in order of base ID.
With the phone in standby, press
1)
[Menu/Select]. Select the HANDSET SETUP menu, and then the SELECT
BASE submenu.
Move the cursor to select the base you want to connect to, or choose AUTO to have the handset automatically
2)
select the base.
Press
3)
[Menu/Select]. SEARCHING will appear in the display.
DECT6015 OM.indb 21
DECT6015 OM.indb 21
8/8/07 4:10:30 PM
8/8/07 4:10:30 PM