Uniden 6035 + 1 - Manual (Page 23)

22
When the base is found, the handset will return to standby. If the base is not found, “SEARCHING” continues 4)
to appear. You can repeat the procedure listed above to return back to the original connection or to fi nd the
different base.
Notes: • You cannot change bases during a call.
•
To confi rm which bases the handset is registered to, open the SELECT BASE submenu and use [ ] and
[ ] to scroll through the list. Press [ ] to close the list and return to standby.
Setting Up the Phonebook
Your handset can store up to seventy names and numbers in your phonebook. When all the phonebook entries are
full, you will hear a beep and MEMORY FULL appears. You cannot store any additional names and numbers unless
you delete some of the existing ones.
You can also use the phonebook entries to store a group of numbers (up to twenty digits) that you may need to enter
once your call connects. This is referred to as chain dialing. See Chain Dialing from the Phonebook on page 29.
Creating Phonebook Entries
To store names and numbers in your phonebook, please follow these steps:
When the phone is in standby mode, press 1) [ ] (on the left side of the four-
way key).
To create a new phonebook entry, press 2) [Menu/Select]. Select the
CREATE NEW menu. EDIT NAME appears.
Enter the name for this entry (EDIT NAME). 3)
Use the keypad to enter a name for this entry; the name can contain up to sixteen characters. (See Entering
Text from Your Handset on page 11 for instructions on entering text.) If you do not want to enter a name for this
entry, your phone will store this entry as . Press [Menu/Select] when you are fi nished.
E d i t N a m e
DECT6035, 6035+1 OM.indb 22 DECT6035, 6035+1 OM.indb 22 8/8/07 3:25:42 PM 8/8/07 3:25:42 PM