Uniden BCT15 - Manual (Page 111)

111
Using the Close Call Feature
Set CC Bands — Lets you select the Close Call band settings. You can turn the
following bands on or off.
VHF Low 1 — (25.0000-53.9800 MHz)
VHF Low 2 — (54.0000-107.9000 MHz)
Air Band — (108.0000 - 136.9750 MHz)
VHF High 1 — (137.0000-224.9800 MHz)
VHF High 2 — (225.0000-319.9750 MHz)
UHF — (320.0000 - 512.0000 MHz)
800MHz + — (764.0000 - 775.9875 MHz, 794.0000 - 823.9875 MHz, 849.0125 -
868.9875 MHz, 894.0125 - 956.0000 MHz,1240.000 - 1300.0000 MHz)
Use the Scroll Control to select a band, press
F
, to select On or Off. Turning
off undesired bands speeds up Close Call operation (works for all frequencies
listed above).
Close Call Hits
When the scanner detects a Close Call hit, it alerts you according to the Override
and Alert settings in the previous section. While listening to a Close Call hit, you
can do any of the following: press [HOLD/RESUME] to hold on the hit frequency,
press
F
to quickly save the frequency into memory, press [L/O] to lock out the
frequency from Close Call and Search operation, or wait for the transmission to
end.
If you are in Close Call Only or Close Call Override mode, and you do not press
any key, the scanner returns to its previous operation after the transmission ends
and the set delay time expires.
If you are holding on the frequency, press [HOLD/RESUME] again to resume the
previous operation.
Close Call Hits are just the last 10 hits received in Close Call mode. The hits go
away when you cycle power (if you want to store it “permanently” press
F
when
the scanner is on the frequency; the scanner then stores the frequency into the
“Close Call” system which shows up in the systems list).
Close Call Hits with Scan
When you turn on this option, the scanner automatically stores and scans the last
10 Close Call hits received. You can assign a Quick Key to this special scan and