Uniden PRO630XL - Manual (Page 13)

UNIDEN Model PRO630XL
13
Connecting the Microphone
Front MIC Jack
Push the MIC plug at the end of the microphone into the MIC Jack until the connection locks
into place. Gently tug the MIC cord to test that the connection is locked. Use the Front MIC Jack
cover which is threaded onto the MIC cord to seal the MIC Jack entry from dust.
Disconnecting the MIC from the Front MIC Jack
Pull away the threaded rubber collar and move it down along the cord. Using the flat blade of a
screwdriver or similar object carefully press the lock tab at the bottom side of the MIC plug and
push it upwards. At the same time tug on the MIC cord to draw back the MIC plug.
Rear MIC Jack
Use the Rear MIC Jack if the main base is mounted where a Front MIC connection is intrusive
or if you wish to use Standard Microphone with the extension cable.
Peel the dust cover from the Rear MIC Jack. Push the MIC plug at the end of the microphone,
or extension cable if using the extension cable into the MIC Jack until the connection locks into
place.
The Front and Rear MIC Jacks can not be used at the same time.
Front MIC Jack Rear MIC Jack