Uniden 9035 - Manual (Page 39)

38
Finding a Lost Handset
Using Hold, Conference and T
ransfer
Finding a Lost Handset
To locate a misplaced handset, press [find] on the base when the phone is in standby. The handsets connected to
the paging base will beep for one minute, and PAGING appears on the handset display. To cancel paging, press
[find] again or any key on the found handset.
Note: Handsets that are not currently connected to this base will not be paged.
Using Hold, Conference and Transfer
Placing a Call on Hold
During a call, press [Int’com/clear] to place the caller on hold. If you leave a caller on hold for more than ten
seconds, the display screen will read, LINE ON HOLD.
To return to the party on hold, press [ /flash] or [
]. The phone will return to the holding party.
Notes: • You can only place a caller on hold for five minutes. Once five minutes has passed, that party’s line will be
disconnected and the phone will return to standby.
• While a call is on hold, Call Waiting and CID on Call Waiting do not work.
Conferencing
If you have more than one handset, up to three people can
participate in a conference call. A three-way conference call
consists of an outside line and two handsets. You can easily
join a call already in progress. The handsets must be currently
connected to the same base (see page 4).
Press [ /flash] or [ ] to join the call.
To hang up, return the handset to the cradle or press [ ].
The other party will still be connected to the call.
.
2.
.
2.
Outside call
Handset #1
Handset #2
DECT ELITE OM.indb 38 13/3/08 3:18:39 PM