Uniden UM-525 - Manual (Page 33)

33
The Setup Screen Options
This chart shows the radio’s Setup Screen options if a WHAM base is not connected.
This chart shows the radio’s menu options if a WHAM base is connected.
• INITIALIZE - Lets you set up the radio. See Using the Initialize Sub menu.
• RADIO - Lets you select and work with additional radio settings. See Using the Radio Sub
Menu on Page 37.
• XTRACK BEEP - Lets you set up the radio’s crosstrack beep function. See “Setting the
XTRACK Beep Options” on Page 40.
• WHAM x 4 - Lets you select and work with WHAM x 4 options. See “Using the WHAM
and WHAM x 4 Sub Menus” on Page 41.
• HAILER RENAME - Lets you assign a name to each hailer for identification.
• DSC CALL - Accessible using MENU/HELP from RADIO MENU
THE SETUP SCREEN SUB MENU
INITIALIZE RADIO XTRACK
BEEP WHAM x 4 HAILER
RENAME SCRAMBLE WHAM
PAGE
USER MMSI ON BASE ID ZONE 1 WHAM 1
VESSEL TYPE CHANNEL
NAME OFF BASE/SUB ZONE 2 WHAM 2
FOG FREQUENCY FIPS CHANGE
LINK EXIT WHAM 3
BACKLIGHT AUTO CH SW RENAME WHAM 4
KEYBEEP LEVEL POS REPLY ANTENNA
SEL EXIT
COLOR PALLET GROUP MMSI EXIT
TIME ADJUST CHANNEL SCAN
TIME ENTRY RX SENS
POS ENTRY DISP TIME/POS
DAYLIGHT SAVE EXIT
UNITS
UIC WATERS
EXIT
THE SETUP SCREEN SUB MENU
INITIALIZE RADIO XTRACK
BEEP WHAM HAILER
RENAME SCRAMBLE
USER MMSI ON BASE ID ZONE 1
VESSEL TYPE CHANNEL NAME OFF LINK CH ZONE 2
FOG FREQUENCY FIPS EXIT EXIT
BACKLIGHT AUTO CH SW
KEY BEEP LEVEL POS REPLY
COLOR PALLET GROUP MMSI
TIME ADJUST CHANNEL SCAN
TIME ENTRY RX SENS
POS ENTRY DISP TIME/POS
DAYLIGHT SAVE EXIT
UNITS
UIC WATERS
EXIT
Using the Setup Screen