Universal Remote Control (URS) RF10 - Manual (Page 18)

33 34
Re-setting RF10 to Or
iginal
Factor
y Default Settings
ERASING COMMANDS
ERASING COMMANDS
Re-setting RF10 to Original Factory
Default Settings
If you want to start with a clean slate, you can re-set the
RF10 its original factory default settings by performing the
following steps.
STEP 1:
Press and hold both the
POWER OFF button and the
STOP button for 10 seconds.
Continue to hold both buttons
as the display flashes ERASE
ten times, then RESET.
The RF10 will then display a
self-testing routine for a few
seconds, then automatically
return to normal operating
mode.
NOTE: This process will essentially erase EVERYTHING
you have programmed into the RF10.
STOP
BUTTON
POWER OFF
BUTTON