beautypg.com

Programming the remote, Continued, C. standard set-up – Universal Remote Control (URS) SL-7000 User Manual

Page 7

background image

Programming the Remote,

(

Continued

)

7

C. Standard Set-Up:

Step 1:

Turn on the device ( TV, VCR, Cable Box, Satellite Receiver, etc. ) that you

wish to operate.

Step 2:

On the Star Light universal remote control, press the corresponding

DEVICE

button

(TV, VCR,CATV, SAT,Audio,or Aux)

and

the MUTE

button simultaneously.

Note: SET will appear in the LCD.

Step 3:

Locate the three digit code number for your brand of equipment from the

code lists found on pp. (

15 31

). Example: TV codes-Sony

001,003

,etc.

Note: If the brand list contains more than one code number,

select the first code listed.

Step 4:

Point the remote control at the devise turned on in Step1 and press in the

three digit code number selected in Step 3.

Note: SET # # # will appear in the LCD.

Your device will turn off when the correct code has been selected. If the
device fails to turn off, go back to Step 3 and select the next three digit
code for your equipment, and press in the code number.

Note: Repeat the above step until the device turns off. When

the device turns off proceed to Step 5.

Step 5:

Press the DEVICE button (TV, VCR, CATV, SAT, Audio, Aux) on the
remote control to store the three digit code that turned off your equipment.

Note: PASS will flash in the LCD indicating that the code has

been stored.

Step 6:

Test the remote control functions with the code just stored.

Example: Power, Channel Up, Volume Up, etc. If any of the buttons do not
perform as they should, please repeat from Step 2 using the next three digit
code until the right code is found.

Step 7:

To program other devices into the corresponding Device button of the
remote control, repeat the above steps with the respective devices and Device buttons.