Universal Electronics Titan M2056-C - Manual (Page 18)

www.urcsupport.com
18
Programming a Macro Key
3. Select a macro key (for example, F1) and
press it once. The mode LED blinks once.
NOTE: You can program up to 15 key presses into one
macro.
6. To add another macro, repeat steps 1 through
5 for the other macro key and the new key
sequence that you wish to assign to that
macro key.
NOTE: Programming more than five macros on the
same macro key overwrites previous settings.
Clearing a Macro Key
3. Press the macro key you want to clear once.
This macro key is now clear and ready for
reprogramming (see “Programming a Macro Key” on
1. On the remote control, press and hold SETUP
until the mode LED blinks twice.
2. Enter 9 9 5. The mode LED blinks twice.
4. Press the key sequence you want to program
into the macro. For example, to turn on your
TV and raise its volume, press TV, POWER,
VOL+, VOL+, VOL+....
5. Press and hold SETUP until it blinks twice.
Now the macro is saved to the assigned macro
key.
1. On the remote control, press and hold SETUP
until it blinks twice.
2. Enter 9 9 5. The mode LED blinks twice.
4. Press and hold SETUP until the mode LED
blinks twice.
SETUP
SETUP
SETUP
SETUP
Titan OCAP Remote Control.fm Page 18 Tuesday, May 27, 2008 1:55 PM