Univex PowerLite 700 - Manual (Page 65)

Fine-Tuning the Projector 65
5. Hold down the Num button and use the numeric keypad to enter
a four digit password.
6. When you see a confirmation message, reenter the password.
7. Press the Menu button, then press Enter to exit the screen.
8. Turn off and unplug the projector.
Starting the Projector With a Password
When the password function is enabled, you see this screen when you
plug in and turn on the projector:
Hold down the Num button and use the numeric keypad to enter the
four digit password.
The password screen closes and projection begins.
Hold down
note
If you leave the projector
plugged in, the Password
screen will not appear. It
appears only if you unplug
and reconnect the power
cord.
Hold down