Uniden UH060SX-2 - Manual (Page 6)

6
SELECTING A CHANNEL
•
Press ch/vol/keylock key momentarily
to activate channel select mode. The
displayed channel will flash.
•
Press volume/channel
▲ or ▼ key to
select the desired channel.
•
Press ch/vol/keylock key momentarily
to exit channel select mode.
•
If no button is pressed within 4 sec the
UH060SX-2 will exit from the channel
select mode.
TO TRANSMIT AND RECEIVE
The UH060SX-2 uses the 40 UHF-CB Channels. For your
reference a list of the available channels and corresponding
frequencies is printed on page 11.
1. Before you transmit, listen for activity
on the selected channel.
2. When the channel is clear, press and
hold the PTT button to transmit.
‘TX’ icon appears on the display.
Hold the radio with microphone approximately 5 cm in front
of your mouth with the antenna at approximately 45° angle
away from your head. Speak in a clear, normal
conversational voice.
3. When you have finished speaking, release the PTT and listen
for a response. ‘TX’ icon then disappears on the display.
While receiving, the ‘RX’ icon is displayed.
UT928ZH_UH060_ENG_0929 9/29/04 3:26 PM Page 6