Uniden UH060SX-2 - Manual (Page 3)

3
GETTING STARTED
BATTERY INSTALLATION
Your UH060SX-2 unit uses the included NiMH battery pack for
power. The unit can be powered with optional 4 AAA ALKALINE
batteries.
To avoid damage to the unit do not mix old and
new batteries.
Do not charge alkaline or non rechargeable
batteries.
Uniden does not represent this product to be
waterproof. Do not expose this product to Rain or
Moisture.
If you don't use the UH060SX-2 for long periods,
Uniden recommend removing the batteries. The
UH060SX-2 is designed to retain the previous user
settings. This feature will continue to use a small
amount of battery power while the unit is switched off.
To install the batteries:
1. Make sure your radio is off.
2. Release the battery cover clip, then
remove the battery cover.
3. Insert NiMH battery pack according
to the orientation on the battery
pack.
OR Insert 4 AAA ALKALINE batteries (not
included) according to the polarity
symbols inside the battery
compartment.
4. Align the battery cover tabs with the
UH060SX-2 tab holes then replace
the cover clip.
UT928ZH_UH060_ENG_0929 9/29/04 3:26 PM Page 3