Uniden UH060SX-2 - Manual (Page 10)

10
TRANSMITTING A CALL TONE
Your UH060SX-2 radio is equipped with 5 selectable call tones
that will be transmitted when the dup/call key is pressed and
held for 3 seconds.
To select a call tone:
1. Press select/power key momentaly twice while in standby
mode to enter Call Tone mode. The current call tone number
(C1-C5) will be indicated.
2. Press the volume/channel
▲ or ▼ key to increase or
decrease the number to the desired call tone. Each tone will
be heard through the speaker.
3. Press select/power key to confirm and exit to standby
mode.
To transmit the selected call tone, press and hold the dup/call
key. The selected tone will automatically be transmitted for a fixed
length of time. Call Tone will be cancelled when the PTT button is
pressed.
KEYLOCK ON/OFF
Press ch/vol/keylock key for 3 seconds to enter keylock on
mode.
Press ch/vol/keylock key for 3 seconds while in Keylock mode
to exit the Keylock mode.
While in Keylock on mode, the UH060SX-2 can still
receive and transmit.
The current selected VOX setting will flash on the display.
Press volume/channel
▲ or ▼ key to adjust the VOX
sensitivity. 1 is the highest sensitivity and 4 is the lowest
sensitivity. VOX can be turned off by selecting ‘oF’ icon.
The ‘VOX’ icon is shown on the display when VOX is selected to
on and VOX Headset is plugged into VOX Headset Jack. The ‘TX’
icon blinks when the voice level is possible to transmit at the
current selected VOX sensitivity level.
Press select/power key twice to confirm the setting and exit to
standby mode.
UT928ZH_UH060_ENG_0929 9/29/04 3:26 PM Page 10