Uniden EXa15580 - Manual (Page 53)

TROUBLESHOO
TING
T R O U B L E S H O O T I N G [ 53 ] www.uniden.com
Symptom
Severe noise interference.
The Caller ID does not display.
The answering system does not
work.
The answering system does not
record any messages.
Messages are incomplete.
After a power failure, the
outgoing message is deleted.
No sound on the base unit
speaker during call monitoring
or message playback.
Cannot access remote call-in
features from another
touch-tone phone.
Suggestion
• Keep the handset away from microwave ovens, computers, remote control toys,
wireless microphones, alarm systems, intercoms, room monitors, fluorescent lights,
and electrical appliances.
• Move the base to another location or turn off the source of interference.
• The call was answered before the second ring.
• The call was placed through a switchboard.
• Charge the handset.
• Your Caller ID service may not be active; contact your local telephone service provider.
• Make sure the the AC adapter is plugged into wall outlet.
• Make sure the answering system is turned on.
• Set the record time to either the one minute or four minute option.
• The memory may be full. Delete some or all of the saved messages.
• The incoming messages may be too long. Remind callers to leave a brief message.
• The memory may be full. Delete some or all of the saved messages.
• Record your personal outgoing message again. The default message should remain.
• Adjust the speaker volume on the base unit.
• Make sure you're using the correct PIN code.
• Make sure that the touch-tone phone you're using can transmit the tone for at least
two seconds. If it cannot, you may have to use another phone to access your
messages.